Acrylic water stone varnish

It is a high quality, acrylic water varnish, nanotechnology, for porous surfaces of building elements for indoor and outdoor use. Protects and decorates porous substrates, such as stones, bricks, cementitious substrates, etc. Due to its special composition, it achieves penetration, while waterproofing the surface, offering strong adhesion, hardness and protection from air pollutants, mold growth, corrosion and natural wear. In addition, due to its content of UV filters, it gives great resistance to weather conditions and intense sunshine. Its hard but at the same time elastic surface makes it suitable for stone floors.

»Strong penetrating ability
»Protects the stone from corrosion
»Revitalizes the appearance of the stone

SURFACE PREPARATION
To ensure better adhesion, the surface must be dry, clean and free of dust, grease, debris, loose old paints or varnishes, etc.
On new stone surfaces: before applying the varnish, wash the surface with water and dry well.
On painted surfaces with mold / algae: remove all residues, scrub and clean the surface, apply KRAFT MOLD BLOCKER and after 24 hours, apply 1-2 coats of KRAFT STONE CARE.
On stone floors: before applying the varnish, remove all residues, wash the surface with water and dry well.

APPLICATION INSTRUCTIONS
»Ready to use.
»Check the surface moisture before painting.
The surface must be well dried.
»Suitable painting tools are: Brush, roller or air gun.
»Mix well before use.
»Apply 1-2 coats of KRAFT STONE CARE for vertical surfaces and 2 coats for floors.
»Apply only in open or well-ventilated area.
»Minimum repaint time about 4 hours.
»Surface drying in about 1 hour at 25 ° C and relative humidity 50%. The drying time is affected by the weather conditions.
»Do not apply at temperatures below 10 ° C and above 35 ° C as well as above 50% relative humidity.

INSTRUCTIONS FOR POST-APPLICATION
“Close the container tightly to keep it in good condition for future use and store it before and after use in a cool place away from exposure to sunlight or frost.
»Clean the tools immediately after use with NITRO 1100 solvent and then with soap and water.