GENERAL CHARACTERISTICS

Elastomeric waterproofing paint for exterior vertical surfaces based on special 100% acrylic UV-curable acrylic resins. It is applied on new and old surfaces made of plaster, concrete, brick, etc. It offers a flawless finish, excellent resistance to adverse atmospheric conditions, air pollution and the coastal environment, without requiring repainting with acrylic paint. It fully covers small surface cracks and monitors contractions and expansions while remaining elastic at temperatures from -25oC to +110oC, giving it sealing properties. The finished surface and the shades remain unchanged for years, with no signs and traces of rain (snake trails). Translated with www.DeepL.com/Translator (free version)

– 4 in 1: Insulates, paints, closes small cracks, breathes
– With 100% acrylic UV-curable acrylic resins
– RESISTANCE to extreme weather conditions and HD shades
– Certified cold material

SPECIAL FEATURES
Certified by the University of Athens, Department of Physics, for its properties as a cold material, with:
Initial full-spectrum solar reflectance SR = 0.86 (300-2500 nm) (ASTM E 903-96 and ASTM G 159-98)
E = 0,88 (ASTM E 408 -71 -2002)
Solar reflectivity index SRI = 108 (ASTM E 1980-01)

SHADES
Available in white and an unlimited number of shades through Vitex’s Colorfull Shade Creation System.

PROCEDURE
Surfaces must be clean, dry and smooth, free of dust, oil or any loose material.
Acrylic Building Stucco is used to fill the holes and patch any cracks.
Old water-coloured surfaces (with lime or glue) are primed with Durovit or Acrylan Unco Eco or Vitosin.
New surfaces made of plaster, concrete, brick, etc., as well as sputtered surfaces are primed with Durovit or Acrylan Unco Eco.

APPLICATION
The product is stirred well before use. It is applied in two coats with a roller, brush or airless gun and diluted up to 15% with water. It should not be applied at temperatures below 5°C, above 35°C and/or relative humidity above 70% or if there is a risk of rain or frost in the next forty-eight hours.
The product is dry to the touch in 2-3 hours and can be repainted after 6-8 hours. These times vary depending on the weather conditions (relative humidity and temperature).
Tools are cleaned immediately after use with water and if necessary with soap or detergent.